Does your Northdale pool pump run for hours every day, right when the sun is strongest? Solar installation in Northdale starts from this: pool pump run for hours every day right. That is good news for solar, if the wiring and timing are set up well. Keywest Lights & Electric (EC13014717) reviews your panel, talks through a SPAN smart panel and wires the inverter. Our licensed solar partner handles the racking and modules.
Request a solar quote in Northdale
Tell us about the property and what you want to keep running. We reply with next steps and a time for the site visit.
Alongside this work, see also jellyfish lighting, and battery backup installation.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Solar installation in Northdale: The pool is often the biggest daily load
In many Florida homes, the pool pump runs more hours than any other motor. It hums along in the middle of the day, which is exactly when an array makes the most power. Lining those two up is one of the simplest ways to use more of your own solar energy.
We look at the pump’s size, its age and how its timer is set. An older single-speed pump draws a lot. A variable-speed pump can do the same job with far less power. We do not sell pumps, but we will tell you when the pump is the real problem.
A 1980s neighborhood
The median home in Northdale was built in 1986, and about half of the homes here went up during the 1980s. About 69 percent are single-family detached houses. The rest are townhomes, duplexes, multi-unit buildings and mobile homes.
Panels from that decade are often still in service. Some are fine. Others are crowded with tandem breakers, or have a bus rated too low to take a solar tie-in on the load side. We open the panel, measure and give you a clear answer.
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
- Projects up to $2 million, with bonding up to $1 million
Pool equipment checks while we are there
If we find a safety issue, we tell you, even if it has nothing to do with solar.
| Item | What we look at | Why it matters |
|---|---|---|
| Pump circuit | Breaker size, wire size, ground. | Pumps run long hours and heat up weak connections. |
| Bonding | The bonding wire around the pool and equipment. | It helps prevent shock near the water. |
| GFCI protection | Whether the pump and lights are protected. | Required for safety near pools. |
| Timer and controls. | How and when the pump runs. | Shifting run time to midday uses more solar. |
| Heater or heat pump. | Its circuit and draw. | It can be a large load if run often. |
SPAN and pool timing
A SPAN panel shows each circuit’s use in an app. You can see exactly how much the pool pump draws and when. Pair that with the inverter app, and you can match run times to the sunniest hours. If you add a battery later, SPAN can pause the pump during an outage so the fridge and lights stay on.
Screens, cages and shade
Many pool homes have a screened enclosure. The frame and screen can cast shade on lower parts of the house, and the partner will account for that in the layout. We look at where conduit can run without crossing the enclosure or the deck. Wire runs that go under pavers or across a screen frame are harder to service later, so we avoid them when we can.
Heaters, lights and the evening swim
A pool heater or heat pump can use more power than the pump itself, mostly in cooler months. Pool and landscape lights add a little more in the evening, after the sun is down. Solar will not cover those evening loads without storage. Knowing that up front helps you set fair expectations for the bill. SPAN shows these loads clearly, so you can decide what is worth running and when.
Rain and equipment placement
During Hurricane Milton in October 2024, a rain gauge the National Hurricane Center lists as “Greater Northdale 0.4ENE” recorded 11.36 inches of rain. Heavy rain finds every low spot. We mount the inverter and disconnects high on a wall, away from splash and pooling water, and we seal each entry point.
Two crews, one schedule
Our electricians do the electrical side: the panel review, SPAN if you want it, the inverter, disconnects, conduit, labels and testing. The licensed partner does the mounting side: racking, flashing and modules. The plan shows both, and we keep the steps in order so no one waits on the other.
From first call to first sunny day
- You send a photo of your panel label and pool equipment.
- We visit and measure the panel and the pool circuits.
- The partner reviews the house for module layout.
- You get one plan.
- Paperwork is filed.
- Any panel work comes first, then the array, then the tie-in.
- Inspection and a walk-through of both apps.
Where incentives stand this year
A home system finished in 2026 will not receive the federal homeowner clean-energy credit, which ended after 2025. Florida still exempts solar equipment from state sales tax, and the state keeps an array’s added value out of your property assessment. Net metering, if your power provider offers it, may credit surplus output. Consult a tax professional; incentives can change.
Doing more than the minimum
Code is the least we may do. Near pools, we pay extra attention. We check bonding and GFCI protection on the circuits we touch. We torque and record every lug. We use wet-rated fittings outdoors. We label every disconnect clearly.
Labor coverage
Most shops cover labor for one year. Ours is two years. With a Member Care Plan, it is five, and we come out once a year to check the inverter wall and panel.
Distance from Seminole
Northdale is about 25 miles from 6248 Seminole Blvd.
Get in touch
Call or text (727) 476-7079. A photo of the pool pump label helps us plan. You can also fill in the form above.
Northdale solar questions
Can solar run my pool pump? During the day, an array can cover much of a pump’s use, especially if you set it to run in the sunniest hours.
Should I replace my pool pump first? Sometimes. An old single-speed pump uses a lot of power. A newer variable-speed pump may cut your use enough to change the array size.
Is my 1980s panel big enough for solar? It depends on the bus rating and the spare spaces. We measure and tell you before anything is ordered.
Do you check pool safety too? On the circuits we touch, yes. We look at bonding, GFCI protection and wire condition and tell you what we find.
Who mounts the modules? Our licensed solar partner. We do all of the electrical work.
How far is Northdale from your shop? About 25 miles from 6248 Seminole Blvd.
Related: solar installation across Tampa Bay · SPAN smart panels in Northdale · generators in Northdale · battery backup in Northdale · electrician in Northdale · Hillsborough County service area. Nearby: solar in Carrollwood · solar in Keystone · solar in Citrus Park · solar installation in Holiday · solar installation in Gibsonton · solar installation in Palmetto · solar installation in Bradenton.
