Living close to Tampa Bay in Apollo Beach means salt in the air on most days. Solar installation in Apollo Beach starts from this: means salt in the air on most days. Salt is hard on metal, and an array has plenty of metal in it. Keywest Lights & Electric (EC13014717) picks enclosures, fittings and routes that hold up near the water, installs a SPAN smart panel on request and ties in the inverter. A licensed partner team handles the racking and modules.
Request a solar quote in Apollo Beach
Tell us about the property and what you want to keep running. We reply with next steps and a time for the site visit.
Other licensed work we already do here includes ev charger installation, jellyfish lighting, panel upgrade replacement, and battery backup installation.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Solar installation in Apollo Beach: Salt, sun and the parts that rust
Near the shore, the weak spots are small. A plain steel screw on a junction box. A conduit strap that was never meant to sit outside. A loose cover that lets damp air in at night. Over a few years, these turn orange, then fail.
We choose outdoor-rated, corrosion-resistant enclosures and hardware. We use fittings rated for wet places. We seal each penetration and keep boxes on the shaded side of the house when we can. Inside the garage, we still pick parts that tolerate humid air, because a garage near the bay is rarely dry.
Newer homes, newer questions
The median home in Apollo Beach was built in 2010. About 70 percent of homes went up in 2000 or later, and about 83 percent are single-family detached houses. Many of these homes have a 200-amp service, which is a good base. The question is usually space, not age. A pool, a spa, a dock lift and a second air system can fill a panel fast.
Matching the array to the house
| Question | Who answers it | What happens next |
|---|---|---|
| Can the panel take the inverter? | Our electricians | We measure the bus, the main and the spare spaces. |
| Which faces of the house get good sun? | The licensed partner. | They sketch a layout and count modules. |
| Where can the inverter live? | Both crews together. | We look for a high, shaded, reachable wall. |
| Should SPAN be part of it? | You, with our advice. | We explain what it adds now and later. |
| Will a battery come next? | You | We plan wire paths so storage is easy to add. |
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
- Projects up to $2 million, with bonding up to $1 million
Storm rain near the water
During Hurricane Milton in October 2024, a rain gauge the National Hurricane Center lists as “Apollo Beach 0.6W” recorded 8.20 inches of rain. Another gauge at the Apollo Beach ROMP TR9-2 well site logged 11.42 inches. That much rain finds every gap. We mount gear above splash height and route conduit so water drains away from the boxes, not into them.
We cannot promise any house is safe from a big storm surge. What we can do is keep the electrical parts as high and as tight as the layout allows, and make the shutoffs easy to find.
Docks, lifts and pool gear
Waterfront lots often have loads that inland homes do not. Boat lifts, dock lights and pool equipment all add circuits outside, near water. We check each one for proper protection while we are there. If something is unsafe, we tell you, even if it has nothing to do with solar.
SPAN can show what these loads use. It is common to find a pool pump that runs far longer than anyone thought. Seeing it in the app helps you trim waste and get more value from the array.
Wind, fasteners and what the partner checks
Wind near open water can be strong, and the mounting has to match. The licensed partner checks the surface, the framing below it and the fastening pattern before any rail goes up. If the covering is near the end of its life, they will say so. Replacing it first is usually smarter than pulling modules off later to do the work.
Our job on that side is to keep every wire run tight and supported. Loose wire flaps in the wind, rubs on edges and wears through. We clip runs under the modules, use listed fittings at every transition and keep exposed conduit short and well strapped.
Seeing the payoff in the app
Once the system is running, you will want to know if it is working. The inverter’s app shows daily output. SPAN shows where that energy goes, circuit by circuit. Put the two together and you can spot a pool heater that runs at the wrong hour or a spare fridge that eats more than its share. Small changes add up across a sunny year.
Planning ahead for storage
Plenty of families start with modules and add a battery a year or two later. A little planning now saves work later. We leave room in the right place, run a spare conduit if it makes sense and choose an inverter path that pairs well with a battery. When you are ready, the next step is smaller.
How 2026 changes the tax math
The federal clean-energy credit for homeowners stopped at the end of 2025, so a system you finish this year will not earn it. In Florida, you still pay no state sales tax on solar equipment. Your county appraiser also has to leave the added value of the system out of your assessment. If net metering is available from your power provider, surplus midday energy can offset your bill. Consult a tax professional; incentives can change.
Code is the floor
Electrical code is where our standard begins. Near salt water we push past it. Every lug is torqued and logged. Grounding is tested, not assumed. Labels are made to last outside. The rapid shutdown switch sits where a firefighter can reach it without searching.
How long we stand behind it
In this trade, a single year of labor coverage is common. We give two. A Member Care Plan adds three more, for five years total, plus an annual visit near the start of storm season.
Distance from the shop
From our shop at 6248 Seminole Blvd, Apollo Beach is about 24 miles.
Getting a first visit on the calendar
Call or text (727) 476-7079. Mention any dock lift, pool or spa so we bring the right tools. The quote box above also reaches us.
Apollo Beach solar FAQ
Does salt air shorten the life of solar wiring? It can, if the wrong parts are used. We choose corrosion-resistant enclosures and fittings and seal every opening.
Can you wire my dock lift into the same system? The dock lift stays on its own circuit. We check it for safety and can show its use in the SPAN app, but the array feeds the whole panel, not one load.
Is my 2010s panel big enough for solar? Often the service is fine, but the panel may be full. We measure and give you options, such as SPAN or a panel upgrade.
Who mounts the racking and modules? A licensed solar partner. We handle the electrical side from the inverter to the panel.
Can I add a battery later? Yes. We plan the layout so storage can be added with less rework.
How far is Apollo Beach from Seminole? About 24 miles from 6248 Seminole Blvd.
Related: solar installation across Tampa Bay · SPAN smart panels in Apollo Beach · generators in Apollo Beach · battery backup in Apollo Beach · electrician in Apollo Beach · Hillsborough County service area. Nearby: solar in Ruskin · solar in Riverview · solar in Brandon · solar installation in Memphis · solar installation in Keystone · solar installation in Palmetto.
