Keywest Lights & Electric is a SPAN Authorized Installer with 20 SPAN installs completed. We install SPAN Panels in Brandon homes and light-commercial spaces along Brandon Boulevard / SR 60, from 1970s tracts west of the mall to 1990s–2000s subdivisions off Lumsden, Bell Shoals and Lithia Pinecrest. Brandon is TECO territory about 31 miles from our Seminole shop, so SPAN work here is scheduled, planned panel replacement — not a same-day drop-in from Pinellas. Licensed (EC#13014717).
Call (727) 476-7079 or request a SPAN consultation. Office 7 AM–5 PM, weekend service, 24/7 emergency calls.
What SPAN does for a Brandon home
A SPAN Panel replaces your existing electrical panel with one you can see and control from your phone. Every circuit is measured and switchable in the SPAN Home app, so you can see what’s using power right now, turn circuits off from anywhere, and get free over-the-air software updates. It uses standard 1-inch breakers and is NEMA 3R rated for indoor or outdoor installation.
In Brandon we see three kinds of SPAN projects:
- Homes adding an EV charger, heat pump, pool heater or induction range. On a 100- to 200-amp TECO service, SPAN PowerUp™ can manage EV charging so the house stays within its service rating, which can sometimes avoid a utility service upgrade.^
- Homes that need a new panel anyway. If your panel is old, full, rusted or a brand insurers flag (Federal Pacific, Zinsco), SPAN is the smarter panel upgrade: you’re replacing the panel either way, and you get monitoring and control in the bargain.
- Homes planning solar and a battery. SPAN lets you choose which circuits get backup power during an outage, change those priorities as the outage goes on, and see how much backup time is left. SPAN says it extends battery life by 40% during an outage.*
Brandon neighborhoods and their panels
Brandon’s median home was built in 1993 (Census ACS 2020–2024), so the housing stock splits into two SPAN conversations:
- Older 1970s–80s neighborhoods west and south of Brandon Blvd, where original panels are crowded, corroded or still Federal Pacific / Zinsco-era equipment that 4-point inspectors and insurers flag. These panels usually need replacing regardless. We assess the TECO service and grounding first, and SPAN goes in as the new panel.
- 1990s–2000s subdivisions off Lumsden, Bell Shoals, Lithia Pinecrest and Providence Road with 150- or 200-amp services that look fine until a remodel kitchen, pool equipment or a Level 2 EV charger asks for breakers and load management that aren’t there.
- Patio homes and townhomes near Westfield Brandon where the unit panel is the homeowner’s and the meter bank belongs to the association — we confirm ownership and HOA rules before we quote.
- Retail and office spaces along SR 60 that want circuit-level visibility and remote shutoff for a tenant build-out or a new kitchen hood circuit. See commercial electrical service.
Larger homes with more than 48 circuits or a service over 200 amps may need more than one SPAN Panel. We size it at the site visit.
SPAN with solar and battery backup
SPAN works with a home’s existing solar and battery system when the battery is on SPAN’s compatibility list. Tesla Powerwall 3 and FranklinWH aPower work with every SPAN Panel model. Powerwall 2, SolarEdge, and Enphase IQ Battery 5P and 10T work with the SPAN Panel MAIN 32. SPAN’s Backup Overload Protection (NEC 2023 Article 702.4) helps prevent brownouts and the service calls that come with battery resets. We confirm your inverter, battery and gateway before we quote.
Don’t have solar or a battery yet? We can add solar, battery backup and energy monitoring through our licensed partner installers as one coordinated project. Our partners install the solar and battery equipment; Keywest Lights & Electric manages the project and handles the electrical work, including the SPAN Panel and interconnection wiring. Solar, battery backup & energy monitoring →
SPAN with a standby generator
Plenty of Brandon homes added a standby generator after recent hurricane seasons. SPAN can work with one, but you should know the limits before you buy:
- The generator connects upstream of SPAN through a listed transfer switch. Generator output never lands in the SPAN Panel, and portable-generator interlocks can’t be installed in it.
- SPAN doesn’t communicate with the generator, so generator power shows as grid power in the app.
- Generator only, no battery: there’s no automatic load shedding. You turn non-essential circuits off by hand in the app, which is still far easier than flipping breakers in a dark garage.
- Generator as part of a compatible battery system: you get SPAN’s full battery outage experience.
Storm season and outages
Hillsborough County storm seasons leave Brandon with multi-day outages more often than most homeowners expect. Owners with batteries learn quickly that a battery wired only to the AC can be empty by morning. With SPAN, you see estimated backup time and decide what stays on, so the fridge, lights and Wi-Fi are still running when you need them.
Permits and TECO in Brandon
Brandon is unincorporated, so electrical permits come from Hillsborough County Development Services through the county’s HillsGovHub portal. There is no separate Brandon city building department. We pull the permit and meet the inspector.
Utility: TECO (Tampa Electric). When the meter can has to be pulled or service equipment changes, we coordinate the disconnect and reconnect with TECO. Meter sockets and service standards follow Tampa Electric’s process — different from Duke Energy work we do on the Pinellas side.
If a load calculation shows the existing service is short even with SPAN PowerUp, a Brandon service upgrade goes on its own line of the quote.
Distance and how we schedule Brandon SPAN work
Our shop is at 6248 Seminole Blvd, Seminole, FL 33772, about 31 miles from central Brandon. That puts Brandon in Tier 3: planned, high-ticket work only. We schedule the consultation, site visit and install day; we do not promise a response time from Pinellas, and we do not advertise all-hours office coverage for SPAN appointments. Office 7 AM–5 PM, weekend service available; emergency calls are answered 24/7 on their own track via our emergency electrician service.
How a SPAN install works
- Consultation call. Tell us about your home, panel, solar, battery, EV plans and any HOA rules.
- Site visit and load calculation. We look at the panel, meter, grounding, and any solar, battery or generator equipment.
- Itemized quote after the site visit. Every part of the job is on its own line. We don’t quote SPAN prices over the phone.
- Hillsborough County permit and TECO coordination when needed.
- Install and commissioning. Most SPAN installs take about a day. We commission the panel, connect it to your existing system, and add whole-house surge protection.
- Inspection and app walkthrough. We meet the inspector and show you how backup priorities work in the SPAN Home app.
Warranty and financing
- 3-year workmanship warranty on our electrical work, extended to 5 years for Member Care Plan members. That’s separate from SPAN’s own 10-year limited panel warranty, which requires installation by SPAN or a SPAN Authorized Installer.
- Financing available through Acorn Finance, subject to credit approval. Check your options without affecting your credit score. Ask us and we’ll include the financing link with your itemized quote.
- Hours: office 7 AM–5 PM, weekend service, and 24/7 emergency calls.
Why Brandon calls Keywest Lights & Electric
- Licensed electrical contractor, EC#13014717, in business since 2010
- Based at 6248 Seminole Blvd, Seminole, FL 33772, about 31 miles away — honest about the drive
- SPAN Authorized Installer, 20 SPAN installs
- TECO / Hillsborough County experience on permitted panel and service work
- Woman-owned, family-run business and Home Depot preferred contractor
- Solar and battery systems are installed by our licensed partner installers; we handle the electrical work and manage the project
Brandon SPAN FAQ
Are you a SPAN Authorized Installer? Yes. Keywest Lights & Electric is a SPAN Authorized Installer, with 20 SPAN installs completed. We’re licensed (EC#13014717) and have done electrical work in the Tampa Bay area since 2010.
How much does a SPAN Panel cost in Brandon? It depends on the SPAN model, your current panel and TECO service, any code corrections, the Hillsborough County permit, and add-ons. We give an itemized quote after a site visit so you see every line before you decide.
Do I need solar or a battery to get SPAN? No. SPAN works as a smart replacement panel on its own, and it’s ready for solar, batteries and EV charging later. Battery backup control does require a compatible battery.
Can SPAN help me add an EV charger without a service upgrade? Sometimes. SPAN PowerUp can manage EV charging to keep your home within its service rating. It requires qualification and enrollment, and we’ll tell you after the load calculation whether it fits your home.^ See also EV chargers in Brandon.
Is Brandon on TECO or Duke Energy? TECO (Tampa Electric). SPAN installs here follow TECO disconnect/reconnect rules when the meter has to move.
Is this the same as the South Tampa SPAN page? No. South Tampa has its own live SPAN page for Hyde Park, Davis Islands and nearby South Tampa addresses. This page is specifically for Brandon addresses. See also SPAN in South Tampa.
Ready for a smarter panel in Brandon? Call (727) 476-7079 or request a SPAN consultation.
* Per SPAN: results from an internal study of SPAN Panel managing backup load priorities in over 1,200 simulated outage situations. Battery backup time will vary based on home energy consumption, backup priorities, and storage systems. ^ Requires qualification and enrollment in SPAN PowerUp to avoid a utility service upgrade. Cost and time savings are site-specific and vary. SPAN®, SPAN Panel, SPAN Drive, SPAN PowerUp™ and the SPAN logo are trademarks of Span.IO, Inc. Keywest Lights & Electric is an independent SPAN Authorized Installer.
Related: SPAN Smart Panel Installation · SPAN in South Tampa · Solar, Battery Backup & Energy Monitoring · Panel upgrades in Brandon · Service upgrades in Brandon · EV chargers in Brandon · Electrician in Brandon, FL · Panel upgrades in Riverview · SPAN in Riverview · SPAN in Temple Terrace · SPAN in Apollo Beach