Under Cabinet Lighting Installation in Redington Beach, FL

Want under cabinet lighting installation in Redington Beach? Keywest Lights & Electric offers under cabinet lighting installation in Redington Beach with hardwired LED strips and bars for kitchens, bars and workspaces. We are licensed and woman-owned, we hide the wire, add a clean switch or dimmer and test the glow.

Request under cabinet lighting installation in Redington Beach

Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.

This field is required.
This field is required.
This field is required.
This field is required.
How did you hear about us?
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.

Besides this, our Redington Beach crew handles backup generator hookups, EV charger installation, a business standby generator and a commercial electrician. Also available here: jellyfish lighting and panel upgrade replacement.

Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

An electrician fitting under-cabinet lighting in a kitchen
An electrician fitting under-cabinet lighting in a kitchen.

Under cabinet lighting installation in Redington Beach: counters you can see

Overhead lights cast shadows on the counter. Lights under the cabinets shine straight onto the work area, so chopping, reading a recipe and cleaning are easier. A hardwired setup looks neat and has no cord or plug to hide.

Where under cabinet lights help

  • Kitchen counters: for prep and cleanup.
  • Coffee and bar areas: for a soft glow.
  • Pantry and laundry cabinets: for task visibility.
  • Home offices: for desk light.
  • Workshops: for bench work.
  • Lanai kitchens: for evening meals.

Strips, bars and puck lights

  • Florida electrical contractor license EC13014717, licensed & insured
  • Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
  • 2-year workmanship warranty, 5 years with a Member Care Plan
  • SPAN Authorized Installer and Home Depot preferred contractor
  • Open 24/7 for electrical emergencies: call or text (727) 476-7079

LED strips give an even line of light. Slim bars are sturdy and easy to link. Puck lights give spots of light. We show you samples and place them where the glow will look best.

Hardwired versus plug-in

A plug-in light leaves a cord on the counter. A hardwired set connects inside the wall and runs to a switch, so there is nothing to see. We hide the cable behind the cabinet trim.

Planning the cable path

We locate a power source, check the wall cavity and plan a route to the cabinet. Where the cabinet is closed in, we use a surface raceway that matches the trim.

Switches and dimmers

You can control the light from a wall switch, a dimmer or a small remote. We install a dimmer rated for LED so the lights stay quiet and smooth.

Color temperature

Warm white feels cozy and cool white feels crisp. We often use a tunable strip so you can choose, or pick a neutral white that suits most kitchens.

Glare and backsplash

A bare LED can reflect off a shiny backsplash. We set the lights toward the front of the cabinet and use a lens that spreads the glow.

Driver and power supply

LEDs need a driver. We place it where it stays cool and can be reached later, and we match it to the number of strips or bars.

Kitchen remodels

During a remodel, we can run the wire before the drywall closes up. See our kitchen remodel electrical page for the full plan.

Counter outlets and the lights

New lights should not overload an existing circuit. We check the load and the circuit and use a different one if the old one is busy.

Older kitchens

The median home here dates to around 1959. Older kitchens often have few outlets and a single ceiling light. Adding task lights makes a real difference.

Salt air and damp

Water covers roughly 73 percent of the town. We use sealed connectors and corrosion-resistant hardware in kitchens near open windows and lanais.

Condos and shared walls

In a building with ten or more units, we respect shared walls and avoid drilling through fire barriers. We coordinate with your manager if needed.

Seasonal homes

With about 21 percent of units used seasonally, a light that turns on by schedule or sensor can make your arrival easier.

Aging in place

Nearly two in five residents are 65 or older. Good counter lighting helps with reading labels and avoiding cuts, and a lighted work area is safer.

Under-cabinet lights for dark pantries

A small strip inside a pantry with a door sensor is a big help. We install one that turns on when you open the door.

Motion sensors

A sensor can switch on the lights when you enter at night. We install a small unit under the cabinet so you never fumble for a switch.

Linking several runs

A long kitchen can need many sections. We link them in a clean line with a single control so the whole counter lights at once.

Cleaning and care

LED strips are easy to wipe. We use covers that can be cleaned without removing the light.

Permits

Low-voltage lighting from an existing power source does not usually need a permit. New circuits may. We explain the rules before we begin.

Cabinet depth and light placement

Deep cabinets need the light toward the front edge, and shallow ones sit best near the middle. We hold the light up with tape before we fasten it so you can judge the view.

Reflections on stone and tile

Glossy granite and tile bounce light back at your eyes. A diffused lens and a slight forward angle give an even wash without a hot spot.

Gluing, clipping and screwing

We mount each bar with clips or small screws so it holds for years. Tape alone can peel in warm kitchens, so we use it only as a temporary hold.

Joining ends and corners

Strips turn corners with a connector and a clean cut at a marked point. We solder or clip each joint and test before we cover it.

Hiding the driver in a cabinet

The driver sits in a spot with air flow and a clear label. We keep it away from stored food, bowls and cleaning products, and make sure it can be reached for service.

Light for glass-front cabinets

A glass-front cabinet can show off dishes with a soft top light. We tuck a strip behind the face frame so you see the glow but not the bulb.

Toe-kick and cove lights

A thin strip along the base of the cabinets makes a gentle night light. We run a separate control so you can switch it on without lighting the whole kitchen.

Planning for a future cabinet change

If you plan to replace cabinets, we leave a loop of extra cable and label each run so a future crew can reconnect them without cutting new holes.

Matching existing recessed lights

When recessed lights are already in the ceiling, we match their color so the under-cabinet glow does not look yellow or blue by comparison.

Warranty

Each job comes with a 2-year labor guarantee. A Member Care Plan extends it to 5 years.

Before we arrive

Clear the counters and cabinet fronts. Tell us how you use the kitchen so we can place the light well.

Safety first

Do not hide cords under a cabinet or run a plug-in strip off an overloaded outlet. If a light feels hot or flickers, turn it off and call us.

Testing the lights

We check that every section lights evenly, test the dimmer at low levels and confirm no wire shows.

Matching existing lighting

We choose a color that matches the recessed or pendant lights so the kitchen has a single, even tone.

Common questions

Can you hide the wires? Yes. We route cable behind trim or in a raceway so it does not show.

Are LED under-cabinet lights hot? LED strips and bars run cool compared with older types.

Can I control the lights from my phone? Often yes, when we use a smart-ready control. We explain the options.

Our trucks leave the shop on Seminole Blvd, about 2 miles away, and work near the Intracoastal Waterway and Gulf Boulevard. We also serve Bay Pines, North Redington Beach, Indian Shores, Madeira Beach and Redington Shores.

Up: Under Cabinet Lighting Installation across Tampa Bay · For everything we do locally, see Redington Beach electrical service.

Nearby: Bay Pines · Seminole

Call or text (727) 476-7079 for under cabinet lighting installation in Redington Beach, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.