Need restaurant commercial kitchen electrical in Seminole? Keywest Lights & Electric wires and repairs restaurant and commercial kitchen electrical in Seminole: hoods, fryers, ovens, walk-in coolers, ice machines and panels. We are licensed and woman-owned, with our shop on Seminole Blvd, and we work around service hours.
Request restaurant commercial kitchen electrical in Seminole
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
Besides this, we do commercial electrical work, generator hookups, eave lighting and charger circuits around Seminole. Crews here also do commercial generator installation. Just down the road: restaurant commercial kitchen electrical in Bay Pines.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Restaurant commercial kitchen electrical in Seminole: when downtime costs money
A restaurant cannot serve food with a dead cooler or a tripped hood fan. Kitchens run hot and wet, with heavy equipment on tight circuits. We repair faults fast, plan new equipment hookups and keep panels organized. The goal is simple: keep the kitchen running and safe.
Equipment we wire
- Fryers and griddles: gas or electric, with controls.
- Ovens and ranges: 208 or 240-volt circuits.
- Walk-in coolers and freezers: compressors and defrost heaters.
- Ice machines and dishwashers: water and power near each other.
- Exhaust hoods: fan motors and make-up air.
- Mixers and slicers: dedicated outlets.
- Lighting: bright, sealed fixtures.
Power sizing and balance
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
Kitchens use a lot of power. We add up the nameplates, check the service and balance loads across phases. Many older restaurants have overloaded panels and warm connections. We use a thermal camera to find hot spots, and we plan upgrades that keep each piece of equipment on a proper breaker.
Ground-fault protection and wet areas
Water and electricity meet in kitchens daily. Outlets near sinks, dish areas and prep stations need ground-fault protection. Floors get washed, and boxes must be sealed. We use wet-rated devices and gasketed covers, and we keep wiring above splash zones where we can.
Hoods, fans and fire systems
A hood fan must run when cooking equipment is on, and fire suppression systems can shut down power and gas. We wire hood controls, make-up air, interlocks and shunt trips so each part works with the others. We coordinate with hood and fire vendors, and we test the system before final inspection.
Remodels and new restaurants
New restaurants and remodels need a plan before equipment arrives. We review the equipment list, mark outlets and circuits on the plans and coordinate with the contractor and the equipment vendor. Rough-in comes before walls close, and trim comes with the equipment. We schedule inspections so you can open on time.
Seminole’s restaurant scene
Seminole and nearby Largo, Madeira Beach and Pinellas Park have many small restaurants, diners and takeout shops in older strip centers. Salt air, humidity and grease wear out electrical parts. We use corrosion-resistant boxes and plan maintenance visits before busy seasons, so a breakdown does not hit during a weekend rush.
Emergency repairs
When a walk-in warms or a fryer trips, call or text (727) 476-7079. We know that food loss adds up quickly.
Heat, grease and electrical wear
Kitchens run hot. Heat dries insulation, and grease collects on boxes and switches. Over time, connections loosen and devices fail. We use high-temperature wire near ovens, seal boxes against grease and test connections with a thermal camera. Quarterly checks can catch hot spots before they cause an outage on a busy night.
Walk-in coolers and refrigeration
Refrigeration is the most expensive thing to lose. A compressor, a defrost heater, a fan motor and a thermostat all need steady power. We check voltage, amps and connections and verify breaker size against the nameplate. A phone alarm or a temperature monitor gives you an early warning and costs little compared with a lost cooler of food.
Back-of-house and front-of-house lighting
Prep areas need bright, easy-to-clean fixtures. Dining rooms need warmer light that flatters food and people. Patios may need string lights, heaters and weatherproof outlets. We plan lighting by zone, with dimmers in dining areas and sealed LED fixtures in the kitchen, and we add emergency lights to meet inspection needs.
Point-of-sale and technology
Registers, printers, kitchen displays and card readers need clean power and a stable network. We add dedicated circuits and surge protection, plan cable paths and install outlets at stations. A tidy setup avoids cords across walkways and makes a repair easier when equipment fails.
Outdoor seating and signs
Patios add electrical needs: outlets, lights, heaters and misters. Wet-rated devices, ground-fault protection and sealed connections are required. Signs need reliable circuits and timers. We handle both so that the outdoor side of your business works as well as the indoor kitchen.
Food trucks, cafes and takeout counters
Small food businesses have the same safety needs on a smaller scale. Coffee shops need circuits for espresso machines and grinders, takeout counters need steady power for warmers, and food trucks need shore power and a clean generator inlet. We tailor circuits to the equipment and keep the install tidy.
Inspection readiness
Health and fire inspectors look for covered boxes, working lights, labeled panels and clear access to shutoffs. We tidy cords, replace missing covers, test ground-fault devices and mark disconnects, so your next inspection is smoother.
Generators and storm planning
An outage in hurricane season can spoil thousands of dollars of food. A generator inlet with a transfer switch lets a rented or owned generator run the coolers, a few lights and the point-of-sale system. We size the switch to the critical loads, label it and show your manager how to start the sequence safely.
Common questions
Can you work before opening hours? Yes. We schedule early or late to avoid the rush.
Do you wire new equipment? Yes. We match circuits to nameplates and install disconnects.
Can you fix a tripping cooler? Yes. We find the cause, which may be a compressor, a heater or a connection.
Do you handle hood controls? Yes. We wire the fan, make-up air and interlocks.
Can you help with a restaurant buildout? Yes. See our restaurant build-out page for details.
Our trucks leave the shop on Seminole Blvd and work near Walsingham Road, Ulmerton Road, Tyrone Boulevard, Seminole City Center. We also serve Largo, Pinellas Park, Bardmoor, North Redington Beach, Belleair Bluffs, Bay Pines, Redington Shores and Gulfport.
Up: Restaurant Commercial Kitchen Electrical across Tampa Bay · For everything we do locally, see Seminole electrical service.
Nearby: Bay Pines · Madeira Beach · Redington Beach · North Redington Beach
Call or text (727) 476-7079 for restaurant commercial kitchen electrical in Seminole, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
