Knob Tube Cloth Wiring Replacement in Seminole, FL

Old wiring in the walls? Ask about knob tube cloth wiring replacement in Seminole. Keywest Lights & Electric replaces knob-and-tube and cloth-covered wiring in older Seminole homes. We are licensed and woman-owned, with our shop on Seminole Blvd. We map the old circuits, plan the new ones and leave walls repaired or ready for your patch crew.

Request knob tube cloth wiring replacement in Seminole

Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.

This field is required.
This field is required.
This field is required.
This field is required.
How did you hear about us?
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.
This field is required.

If you are planning more work, see our Seminole pages for EV charging, generators, commercial service and JellyFish lighting. Crews here also do commercial generator installation.

Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

An electrician replacing old cloth-covered wiring
An electrician replacing old cloth-covered wiring.

Knob tube cloth wiring replacement in Seminole: why it is done

Knob-and-tube wiring was common before 1950. It uses single wires held by ceramic knobs and tubes, with no ground. Cloth-covered cable followed and lasted into the 1960s. Insulation on both types dries and cracks with age. Many insurers will not cover a home with them, and the wires cannot safely carry modern loads.

How to spot it

  • Attic: single wires on ceramic knobs along joists.
  • Panel: fuses, or cloth-covered cable entering the box.
  • Outlets: two-prong receptacles with no ground.
  • Wire: black or brown cloth insulation, brittle to the touch.
  • Splices: wires twisted and wrapped in tape.
  • Odd behavior: flickering lights, warm switches and a burnt smell.

Why it is a concern

  • Florida electrical contractor license EC13014717, licensed & insured
  • Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
  • 2-year workmanship warranty, 5 years with a Member Care Plan
  • SPAN Authorized Installer and Home Depot preferred contractor
  • Open 24/7 for electrical emergencies: call or text (727) 476-7079

Old wires carry heat poorly, especially when buried under insulation, which was added to many attics after the wiring was installed. Overloaded circuits are common, because modern homes use more power. Splices made with tape can loosen and arc. An ungrounded circuit gives no safe path in a fault. These risks add up in a house with many changes over the years.

How we plan a replacement

We start with a survey. We trace every circuit, record which outlets and lights each one serves and check how the panel is loaded. Then we write a plan that lists new circuits, panel size and the areas where we need to open walls or ceilings. You get a clear scope and an order of work.

Working in finished homes

Rewiring a lived-in house calls for patience. We fish new cable through attics, crawl spaces and wall cavities, using as few openings as we can. We protect floors, cover furniture and keep dust down. Many homes can be done in stages, room by room, so the family can stay in the house.

Seminole’s older homes

Most Seminole homes date from the 1960s and later, so true knob-and-tube is rare here. About 28% were built in the 1970s and the median year is 1979. Still, additions, older cottages and some earlier houses near Gulfport and Bay Pines may contain cloth cable or mixed wiring. We check before we assume.

Insulation and attics

Never cover knob-and-tube wire with insulation. If an attic has it, we recommend replacing the wiring before more insulation goes in. Pinellas heat makes attic work hard, so we schedule early in the day and plan breaks. We keep a clean path for the insulation crew to follow after the new wiring is finished.

Permit and inspection

Replacement needs a permit and inspections, and often a new panel. We handle the paperwork, meet the inspector and provide a letter for your insurer. Call or text (727) 476-7079.

What a typical replacement day looks like

We arrive, cover floors, shut off the circuits we are working on and set up a work light. One crew member works in the attic or crawl space while another works at devices inside the rooms. Cable is pulled from the panel to each box and connected. By evening, we restore power to the finished circuits and label them. Open work areas are made safe before we leave.

Patching and finish work

Fishing cable often needs small openings in drywall or plaster. We keep them as small as possible and tell you where they will be before we cut. Many owners hire their own painter or handyman for the patches, while others ask us to coordinate. Plaster walls in older homes take extra care, so we plan for it and give you a realistic scope.

Panels and capacity

Old homes often have small panels with few breakers and low amp ratings. New wiring is a good moment to upgrade the panel and add circuits for modern use, such as a dedicated kitchen line, air conditioning and a dryer. We size the panel from a load calculation and leave room for growth, including an EV charger if you want one later.

Insurance and resale

A home without old wiring is easier to insure and sell. After the work, we provide a letter and a copy of the inspection record. Buyers and insurers like to see paperwork, and it saves time during a closing. Keep the documents with your house records. If you sell, they are useful proof of safe, modern wiring.

Partial replacement options

A whole-house rewire is not always needed at once. Some owners replace the circuits with the highest risk first, such as kitchens, bathrooms and attic runs, then finish later. We write a plan that keeps each stage safe, removes ungrounded circuits where feasible and avoids paying twice for panel work. Clear stages help owners budget with confidence.

Common questions

Is knob-and-tube wiring illegal? Existing wiring is not always removed by law, but new work must meet current code, and insurers often refuse coverage.

Do you have to open all my walls? Not always. We fish cable through attics and crawl spaces when we can.

Can I stay in the house? Usually yes. We work in stages and restore power each day.

Will you remove the old wire? We disconnect and remove what we can reach and cap the rest safely.

How long does it take? Many homes take several days to a couple of weeks, depending on size and access.

Our trucks leave the shop on Seminole Blvd and work near Lake Seminole, 113th Street North, Ulmerton Road, Park Boulevard. We also serve Kenneth City, Largo, North Redington Beach, Belleair Bluffs, Redington Shores, West Lealman, South Pasadena and Redington Beach.

Up: Knob Tube Cloth Wiring Replacement across Tampa Bay · For everything we do locally, see Seminole electrical service.

Nearby: Bay Pines · Madeira Beach · Redington Beach · North Redington Beach

Call or text (727) 476-7079 for knob tube cloth wiring replacement in Seminole, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.