Remodeling a bathroom in Bay Pines? Keywest Lights & Electric handles bathroom remodel electrical in Bay Pines, with new lights, ground-fault outlets, fans and heated floors. We are licensed and woman-owned, and the shop is about a mile away.
Request bathroom remodel electrical in Bay Pines
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
Our Bay Pines pages cover a car charger circuit, backup generator hookups, permanent Christmas lights and panel replacement too. Just down the road: bathroom remodel electrical in Seminole. Also available here: commercial electrician and commercial generator installation. Just down the road: bathroom remodel electrical in Indian Shores, bathroom remodel electrical in Bear Creek and bathroom remodel electrical in South Highpoint.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Bathroom remodel electrical in Bay Pines: planning the wiring before the tile
A remodel is the best time to fix bathroom wiring. Walls are open, so new wire is easy to run. We plan outlets, lights, fans and switches with you and the contractor, so the electrical work is done before drywall and tile cover it up.
What a bathroom remodel may need
- Ground-fault outlets: near sinks and tubs.
- Vanity lighting: on both sides of the mirror.
- Exhaust fan: vented outdoors.
- Shower light: rated for wet use.
- Heated floor: thermostat and dedicated circuit.
- Dedicated circuit: for a hair dryer or a bidet seat.
Homes from the 1970s
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
The median Bay Pines home dates to 1970. Bathrooms from that era may have one ceiling light, one outlet and a thin cable. During a remodel, we replace outdated parts, add ground-fault protection and run a separate circuit when the load calls for it.
Lighting that works
A single light overhead casts shadows. Side lights at the mirror give an even glow. We help you choose fixtures, bulbs and dimmers, and place them at the right height.
Exhaust fans
A fan that vents outside protects new paint and tile. We size the fan to the room, run a duct to an outdoor cap and fit a timer or humidity switch.
Heated floors
Electric floor heat needs a thermostat and a sensor. We run the circuit, install the controls and test the mats before tile goes down. We label the breaker.
Condos and villas
Many Bay Pines units sit in older buildings. Remodel plans may need board approval, and noise hours may apply. We provide a short scope sheet and work within building rules.
Aging in place
With about two in five residents 65 or older, many remodels add walk-in showers. We place switches within easy reach, add bright lights for safety and consider night lights along the path to the bath.
Working with your contractor
We coordinate with the tile and plumbing crews so no one cuts a cable by mistake. We mark the wire route and test circuits before the walls close.
Rough-in and final
The rough-in visit comes before drywall, and the final visit comes after the vanity and fixtures are set. Each step is tested and noted.
Moisture and Boca Ciega air
Humid air loads a bathroom for hours. We pick damp-rated fixtures, seal boxes and test that every outlet is protected.
Smart switches and night lights
Motion-sensing night lights and smart switches add comfort. We install them where they help and keep wiring neat.
Cleanup
We protect floors, vacuum dust and haul our debris. We leave a labeled panel and a short list of what changed.
Layout day with the contractor
Before the walls open, we like to stand in the room with whoever is doing the tile and the plumbing. We mark where the vanity light will sit, where the outlets go and where the fan duct must run. A ten-minute talk at this stage prevents a cut cable or a switch that ends up behind the door.
Wet-zone lighting
A fixture inside a shower needs a damp or wet rating on the label. We read the rating, not the box art, and we check that the trim matches the housing. A recessed light over the tub is easy to install during a remodel and hard to add later.
Mirrors with built-in lights
Lighted mirrors and defoggers need a nearby power point or a hardwired box behind the glass. We place the feed before the mirror is hung so no cords show.
Shared walls in condos
A bathroom in a Bay Pines condo often shares a wall with a neighbor. We keep new boxes off the shared wall when we can and follow the building rules for noise hours and elevator use.
Permits during a remodel
Most bathroom remodels need a permit when wires move. We prepare the permit paperwork and set the rough-in inspection before the drywall goes up. A passed final inspection closes the file and protects your resale record.
Dimmers, color and the right bulb
Warm light around 2700 to 3000 Kelvin flatters skin and makes tile look rich, while cooler light helps with shaving or makeup. We install dimmers rated for LED loads so bulbs do not buzz or flicker, and we label which switch runs which fixture. Match the bulbs on both sides of the mirror, and keep spares in the same color.
Towel warmers, bidet seats and extra outlets
A towel warmer, a bidet seat or a charging drawer in the vanity each need a nearby outlet. Plan them early, because the box must land inside a cabinet or beside the toilet at a safe height. We use covers that keep spray out and keep the cord path tidy.
Panels, breakers and spare capacity
Old panels can limit a remodel. If the box is full or warm, we say so before the walls close, and suggest a subpanel or a larger panel when it will pay off in the long run.
Common questions
Do I need a permit for a bathroom remodel? Usually yes when wiring changes. We handle it.
Where do outlets go? Near the vanity, with ground-fault protection. We follow code for spacing.
Can you add a heated floor? Yes. We install the thermostat and a dedicated circuit.
Can you work with my contractor? Yes. We coordinate the timing and the wire routes.
Do you upgrade old wiring? Yes, when it is unsafe or too small for the plan.
How long does the electrical work take? Most bathrooms need one to three visits across the job.
Our trucks leave the shop on Seminole Blvd, about a mile away, and work near Seminole Boulevard, Long Bayou, Boca Ciega Bay and Bay Pines Boulevard. We also serve Kenneth City, Pinellas Park, Madeira Beach, Bardmoor and Redington Shores.
Up: Bathroom Remodel Electrical across Tampa Bay · For everything we do locally, see Bay Pines electrical service.
Nearby: Madeira Beach · Redington Beach · North Redington Beach · Bardmoor
Call or text (727) 476-7079 for bathroom remodel electrical in Bay Pines, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
