Need weatherhead repair in Redington Beach? Keywest Lights & Electric provides weatherhead repair in Redington Beach when the service mast leans, the cap is cracked or the wires pull loose after a storm. We are licensed and woman-owned, we coordinate the power provider shutoff, make the repair and test the service.
Request weatherhead repair in Redington Beach
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
Neighbors in Redington Beach also book us for generator installation, a car charger circuit, commercial generator installation and a commercial electrician. We also handle jellyfish lighting and panel upgrade replacement.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Weatherhead repair in Redington Beach: where the power enters your home
The weatherhead is the curved cap at the top of the service mast. The wires from the street come in through it and run down to the meter. Wind, falling limbs and age can bend the mast or crack the cap, and water can then run into the service.
Signs of a damaged weatherhead
- Leaning or bent mast: wind or an impact.
- Cracked or missing cap: water can enter.
- Wires pulled tight or sagging: the drop is stressed.
- Rust or green corrosion: salt air has eaten the metal.
- Water stains by the meter: water traveling down the conduit.
- Flickering after storms: a loose connection.
What the mast and weatherhead do
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
The mast holds the service wires above the clearance the code requires and carries them into the meter base. The weatherhead keeps rain out while letting the wires pass. A drip loop keeps water on the outside.
The power provider’s side
The service drop from the pole belongs to the power provider. They must disconnect it before we work and reconnect it afterward. We schedule that visit and make the repair on our side.
What we repair
We replace the weatherhead, re-secure or replace the mast, install new clamps and brackets and rebuild the connections to the service wires. We use parts rated for outdoor service.
Mast height and clearance
The wires must clear the house, driveways and walkways by set distances. We check the height and brace the mast so it holds the wires at the right point.
Drip loops and sealing
A drip loop lets water run off the wire before it reaches the cap. We shape each loop and seal the entry so water cannot travel down the conduit.
Bracing and standoffs
Tall masts need support. We use standoff brackets or guy-style bracing as the code allows so wind does not pull on the wall or the meter.
Corrosion from salt air
Water covers roughly 73 percent of the town. Salty breezes turn bare steel green and flaky, and a mast can look solid from the ground while its wall is paper thin where a clamp has held water.
Storm damage and falling limbs
After a storm, we check the mast, the cap, the connections, the meter base and the panel. We tell you what is safe to repair and what needs the power provider first.
Older homes
The middle home by age here went up around 1959. Masts from that period were often light-gauge steel, and the wire coming through may have dried out and cracked at the bend.
Electric heat and big loads
With nearly every home heating by electricity, the service wires carry heavy current for months. We confirm the conductor size at the cap and tighten each splice.
Condos and service in a bank
Larger buildings often bring power in at a single central point. We talk with the manager first and limit our repair to the equipment that serves your home.
Seasonal homes
About 21 percent of units here are seasonal. With no one home to notice a drip, a cracked cap can leak for weeks. An inspection each spring catches it before the wet season.
Aging in place
Nearly two in five residents are 65 or older. Losing service is more than an inconvenience for someone on oxygen or a powered bed, so we treat a leaning mast as urgent and plan around medical needs.
Replacing the meter base at the same time
When the mast is damaged, the meter base often is too. We inspect both and can replace them together. See our meter base replacement page.
Overhead and underground service
Some homes take power overhead and some underground. Weatherhead repair applies to overhead homes, and we can talk through options if you would like to change.
Permits and inspection
A mast or weatherhead replacement needs a permit and an inspection. We handle the paperwork and the scheduling, and the provider reconnects when approved.
Safety around downed wires
A wire on the ground may be live. Stay far back, keep others away and call the power provider and 911 before calling us.
What happens on the day
The provider disconnects, we remove the old parts, install the new mast and cap, reconnect the wires, inspect and call for reconnect.
Conduit, couplings and straps
A mast is made of rigid pipe and couplings. We check each joint and strap and replace any that are rusted or loose, so no strain falls on the wire.
Service conductors and splices
The wires between the cap and the meter must be continuous. We replace any damaged length rather than patch it, and we use approved connectors for the drop splices.
Bonding the mast
The mast must connect to the grounding system. We check the clamp and the bond so a fault has a safe path to ground.
Trees near the service
Branches that touch the drop can wear the insulation. We tell you when a limb is a risk and recommend that a tree service trim it safely.
Wall penetrations
Where the mast enters the wall, water can seep in. We seal the opening and flash it so the wall stays dry behind the meter.
Lightning and surge clues
Burned insulation at the cap or a blackened clamp may show a past surge. We note it and recommend protection at the panel.
Checking the neighbor’s side
A shared drop may feed more than one home. We note this for the power provider so no one is left in the dark by our work.
Warranty
Each job comes with a 2-year labor guarantee. A Member Care Plan extends it to 5 years.
Before we arrive
Keep people and vehicles away from the area under the mast and tell us what you saw or heard.
Safety first
Do not touch a leaning mast or a loose wire, and do not trim limbs near the service wires. Call us and the power provider.
After the repair
We leave a note with the parts replaced and photos of the finished work.
Common questions
Who repairs a weatherhead? A licensed electrician repairs the mast and the cap, while the power provider handles the drop wires.
Is a bent mast an emergency? It can be. Stay clear and call us, since a stressed wire can pull loose.
How long does weatherhead repair take? Usually a few hours, plus the power provider’s shutoff and reconnect.
Our trucks leave the shop on Seminole Blvd, about 2 miles away, and work near the Intracoastal Waterway and Gulf Boulevard. We also serve North Redington Beach, Bay Pines, Madeira Beach, Redington Shores and Indian Shores.
Up: Weatherhead Repair across Tampa Bay · For everything we do locally, see Redington Beach electrical service.
Nearby: Seminole
Call or text (727) 476-7079 for weatherhead repair in Redington Beach, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
