Need RV outlet installation in South Highpoint? When a coach needs a 30-amp or 50-amp hookup at the drive, that job is RV outlet installation in South Highpoint with Keywest Lights & Electric. Our Seminole Blvd shop sits a short drive of about 7 miles away. The contractor is licensed and woman-owned.
Request rv outlet installation in South Highpoint
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
Alongside this job, South Highpoint neighbors hire us for business electrical work, a commercial generator hookup, a home EV charger, generator installation, a generator interlock, permanent Christmas lights, a panel upgrade, permanent lighting along the eaves and a 240-volt outlet.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

RV outlet installation in South Highpoint is the pedestal or the driveway receptacle, not a dryer plug
The scope here is the coach hookup itself: a listed TT-30, a listed 14-50, a pedestal or a wall mount, and a feeder sized for that coach. Dryer, range and shop 240-volt pages are separate. This page stays on the RV hookup.
A short driveway on a mid-1970s lot
Lots here are often short and inland, with almost no water and no dock to invent. We place the pedestal or the wall mount where the coach can sit without blocking the sidewalk or a neighbor’s drive. We do not set a pedestal in a drainage swale or in the travel path of a mail truck.
30-amp versus 50-amp, decided by the coach
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
A 30-amp TT-30 and a 50-amp 14-50 are not interchangeable. We read what the coach needs, and we land the listed configuration. We do not leave a 14-50 and a cheater cord as the only plan if the coach is a 30-amp unit, or the other way around, unless you asked for both on a listed pedestal.
A feeder that has to match the load
A 50-amp coach can ask more of a 1970s house panel than a single spare 20-amp space can give. We check the panel, the feeder and the breaker. If the panel cannot carry it, we explain that and we design a path that can. A 50-amp face on a leftover 30-amp feeder is not a hookup we will complete.
Rented lots and a pedestal the owner has to approve
A two-family yard often shares a drive. The owner or the office has to approve a new pedestal or a new feeder. We stay on the drive that hired us, and we will not trench the other unit’s yard from a tenant request alone.
Manufactured homes and a tight side yard
Beside a manufactured home the side yard is often tight and the factory feeder is short. We set a listed pedestal or wall mount the yard can actually hold. A tall pedestal jammed into a narrow, soft patch is not a hookup we will leave.
What this page will not include
Sewer and water spigot work is a plumbing job, not this electrical ticket. We do not invent a dock or a salt-bay shore-power post; this community has almost no water. This hookup page does not invent a review or a price.
A pedestal slip after the visit
At close-out we leave a pedestal slip. It lists the receptacle type, the breaker size and the mount location. Keep it with the house papers or in the coach book.
Paperwork when a new RV feeder goes in
A swap on an existing, correctly sized RV circuit can be a short visit. A new feeder, a new pedestal or a new trench usually needs forms. Required forms get filed on our side, and we stay when an inspection is set. Mail that says Clearwater still leaves the parcel under unincorporated Pinellas rules.
Coverage on RV-hookup work
Pedestals, receptacles, feeders and breakers we install carry two years of workmanship coverage. On the Member Care Plan at /member-care-plans/, that coverage lasts five years. A coach cord you brought that fails on its own stays outside coverage.
A 14-50 dryer face used as an RV hookup
A leftover 14-50 dryer face on a house wall is not an outdoor RV hookup. We land a listed, weather-resistant RV device and a listed in-use cover, or a listed pedestal. We do not leave an indoor dryer face as the only outdoor hookup.
A GFCI that trips every time the coach air starts
Some coaches trip a GFCI as soon as the air starts. We use a listed protection method the rules and the listing call for, and we explain what you are getting. We do not leave a device that trips on every startup and call the hookup finished.
Headlamps along 34th Street North and a pedestal we will not hide in the glare
A lot near 34th Street North can have tight driveway geometry. We place the pedestal where a coach can line up without sitting in the travel lane. We do not hide the pedestal behind a hedge the driver cannot see at night.
An aluminum branch leftover we will not ignore
A mid-1970s feeder to a side yard can be aluminum. We use a listed method for that cable, or we replace the run if that is the honest path. We do not land a new copper receptacle on a bare aluminum conductor with no listed connector.
A 20-amp backyard receptacle used as a camper hookup
A 20-amp backyard receptacle is not a coach hookup. We will not leave a household receptacle and a cheater as the RV plan. A listed 30-amp or 50-amp device is the honest hookup.
A pedestal in a mulch bed that stays wet
A pedestal in a wet mulch bed rusts early. We set it on a listed, raised base or we move it to firmer ground. A pedestal standing in wet mulch is not a finished hookup.
A surge device on the pedestal we will only land if it is listed
Some owners want a surge device at the pedestal. We land one only when it is listed for that use. We do not tape a household strip inside a pedestal and call the coach protected.
A pull-through on a corner lot near Ulmerton
A corner lot near Ulmerton Road may want a pull-through rather than a back-in. We place the pedestal where that pull-through can work without sitting in the corridor. We do not set the pedestal on the road side of the walk.
A 50-amp plug left hanging on a house hose bib
A 50-amp plug hanging on a house hose bib is not a hookup. We land a listed device and we give the cord a listed, short path. A cord over a hose bib is not a finished pedestal.
A dog fence transformer sharing the same post
A dog-fence transformer sharing the pedestal post can trip or noise the coach. We give the fence transformer its own listed 120-volt path. We do not land both on one post device.
A gravel pad we will not call a listed pedestal base
Loose gravel under a pedestal is not a listed base. We set a listed base or a firm pad. A pedestal rocking in gravel is not a finished mount.
A 15-amp garage opener receptacle used as a camper feed
A 15-amp garage opener receptacle is not a camper feed. We will not extend that device to a coach. The coach gets its own listed hookup.
A late-night hookup light on the pedestal
Some owners want a small listed light on the pedestal so a late arrival can see the plug. We land a listed, shielded lamp only when the pedestal and the circuit can take it. A work light taped to the post is not a finished feature.
A 30-amp to 50-amp dogbone left in the coach bay
A dogbone adapter left in the coach bay is not a substitute for the listed hookup the coach actually needs. We land the configuration the coach is listed for. A dogbone as the only plan is not a finished pedestal.
A wheel chock that hid the only ground lug
A wheel chock or a leveling block can hide the only ground lug on a low pedestal. We keep that lug inspectable. A buried lug under a chock is not a finished ground.
Common questions
Can you install a 50-amp RV outlet at a mid-1970s house? A: Yes, when the panel and the feeder can carry it and we can land a listed outdoor device or pedestal. If the panel cannot carry a 50-amp load, we say so first.
Is this the same as a dryer outlet? A: No. A dryer receptacle and an RV hookup have different listings, different locations and different pages. We will not treat a laundry face as an outdoor RV hookup.
Will you work on a rented driveway? A: Yes, once the owner or office approves. We leave the pedestal slip for that file.
We roll out from Seminole Blvd and reach South Highpoint in a short drive (about 7 miles). Common stops include 34th Street North, 49th Street North, Ulmerton Road and Roosevelt Boulevard. Nearby towns we serve include Clearwater, St. Petersburg, Largo, Feather Sound and Pinellas Park.
Up: RV Outlet Installation across Tampa Bay · For everything we do locally, see South Highpoint electrical service.
Cities next door: Bay Pines · Seminole
Call or text (727) 476-7079 for rv outlet installation in South Highpoint, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
