Need kitchen remodel electrical in South Highpoint? Keywest Lights & Electric handles kitchen remodel electrical in South Highpoint when a 1970s kitchen is opened for new cabinets, a new island or new appliances. We are licensed and woman-owned, and we reach these houses from our Seminole Blvd shop about 7 miles away.
Request kitchen remodel electrical in South Highpoint
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
From South Highpoint we also take calls for backup generator hookups, emergency electrician visits, permanent Christmas lights and a home battery system.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Kitchen remodel electrical in South Highpoint starts with the appliance list
A range, a dishwasher, a microwave, a refrigerator and a disposal each have a nameplate. We read those first, we plan the circuits and we do not guess at a leftover 1974 receptacle behind an old stove. This page is the kitchen only. A whole-house remodel or a new-room addition is a different scope.
Islands, a peninsula and a backsplash box
A new island often needs a receptacle in the end or on a raised back. The box has to take a granite shop’s cut. We set that box before the top is templated. We keep the cable out of a sink cabinet. We will not land a loose whip under a drawer. A peninsula gets the same care.
Countertop GFCI and a 1970s small-appliance circuit
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
Many original kitchens here have too few countertop points. Some still have an ungrounded split receptacle with no ground-fault protection. We add the protection at the first receptacle or at the breaker. We space new points along the counter. We label the downstream outlets. A decorative plug strip under a cabinet is not a substitute for a listed receptacle.
Electric ranges and a tight can
Nearly all households here heat with electricity, and many kitchens also have an electric range. That is a heavy pair of loads. We confirm the range circuit, we inspect the receptacle or the whip and we say so if the old can cannot take a new 240-volt appliance along with the heat. A dryer receptacle reused as a range outlet is not acceptable.
Manufactured-home kitchens
A manufactured-home kitchen has thin walls, a small interior main and a feeder that may already be busy. We check the pedestal and the bonding before we add a circuit. A range or a new island in that kitchen is only safe if the feeder can carry it.
What we usually rough in
- Small-appliance circuits: for the counters, with ground-fault protection.
- Appliance circuits: range, dishwasher, disposal, microwave, refrigerator.
- Lighting: a ceiling box, under-cabinet feeds and a hood switch when the plan asks.
- Island or peninsula receptacles: set before the top is finished.
- A filled directory card: so the new kitchen is easy to find in the old can.
Renters, owners and a temporary counter
Renters occupy close to half of these households. A tenant can show us the kitchen, but the owner has to approve a wall opening and a new circuit. During the remodel we can keep a temporary counter circuit live so a fridge does not sit on an extension cord. We write that temporary plan before we start.
Cabinet-out visit, then device visit
We rough while the cabinets are out. We are present for the inspection if one is required. We return to set devices after the counters and the backsplash are in. The truck is marked. If a range has not arrived, we leave the circuit capped and safe.
Permits for a kitchen electrical remodel
New circuits and relocated boxes usually need a permit. We handle the paperwork, we stay for the look and we do not name a reviewing desk or invent a wait. The parcel’s Pinellas County rules apply even when the mail says Pinellas Park or Clearwater.
How we stand behind a kitchen remodel
Kitchen circuits we install carry a two-year workmanship warranty. Homes on the Member Care Plan at /member-care-plans/ get five years on that same work. Appliances you already bought are covered only as the invoice states.
A hood switch, a makeup-air interlock and a clock-outlet
A range hood needs a switch in a sensible place, and some hoods also need a makeup-air interlock that we only install when the hood listing asks for it. An old clock-outlet in a backsplash is retired or replaced with a listed box, not hidden behind a new tile with a live feed still in it.
A disposal switch and a dishwasher air-gap box
The disposal switch is set where a wet hand can reach it, and the dishwasher gets a listed box or a whip that is not buried under a sink trap. We keep those two circuits distinct, and we test both before the cabinet shop hangs the doors.
A microwave niche and a hidden junction
A microwave niche needs a listed box, not a hidden junction tucked above the cabinet. We place that feed before the box is scribed in, and we leave the connection accessible. A wirenut buried behind a plank is opened and moved to a proper box.
Toe-kick lighting and a centered island box
Toe-kick lighting gets a listed low-profile feed. The driver stays accessible in a cabinet. It is not buried in a toe-kick with no door. If an island light is in the plan, we center the box on the finished island, not on the old room. We leave a whip long enough for a last-inch move when the cabinet shop sets the top.
A pantry circuit and a ceiling box in a galley
A galley kitchen often needs a pantry light and a ceiling box that is actually centered on the walking line, not on the old table. We move that box while the ceiling is open, and we do not leave a canopy hanging off-center over a new island cut.
A soffit can and a heat-lamp leftover
A soffit can over the sink is set before the cabinet crown is on, and a leftover heat-lamp in an old ceiling box is retired if the new plan does not call for it. We cap that feed in a box, and we do not leave a heat-lamp circuit live above a new wood hood.
A wine fridge and a second sink
A wine fridge or a second prep sink, when they are in the plan, get their own listed points and, at the sink, the same ground-fault protection as the main counter. We do not share those with a lighting switch. A leftover appliance garage with a live ungrounded receptacle is corrected or retired.
A desk nook at the end of a galley
Some 1970s galley kitchens end in a small desk nook. That nook gets a dedicated receptacle and a light, and we keep it off the disposal switch. A tangled power strip under the old desk is removed.
A pot-rack box and a leftover transom light
If a pot rack or a hanging rail is in the plan, we set a listed box on a solid backing, not on drywall alone. A leftover transom or soffit light that no longer has a purpose is capped in a box and retired from the switch.
Common questions
How long does kitchen remodel electrical in South Highpoint usually take? A: A typical rough-in and a device visit follow the cabinet schedule. A tight panel or a new range circuit can add a step.
Can you add an island receptacle after the top is on? A: It is much cleaner if we set the box before the top is templated. After the top is on, the work is harder and may not be possible without a visible cut.
Do you work in manufactured-home kitchens? A: Yes. We look at the pedestal, the feeder and the bonding first, and we tell you if the new appliances will fit.
Our shop is on Seminole Blvd, about 7 miles from South Highpoint. Crews work near Roosevelt Boulevard, Ulmerton Road, 49th Street North and 34th Street North. We also serve Feather Sound, Clearwater, Largo, Pinellas Park and St. Petersburg.
Up: Kitchen Remodel Electrical across Tampa Bay · For everything we do locally, see South Highpoint electrical service.
Cities next door: Seminole
Call or text (727) 476-7079 for kitchen remodel electrical in South Highpoint, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
