Need dock marine electrical in Seminole? Keywest Lights & Electric wires docks, boat lifts and seawalls for waterfront homes in Seminole. We are licensed and woman-owned, with our shop on Seminole Blvd. Water and electricity are a dangerous mix, so we use marine-rated parts and ground-fault protection.
Request dock marine electrical in Seminole
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
Other Seminole jobs our crew takes on include standby generators, EV chargers, JellyFish holiday and event lighting and business electrical work. Crews here also do commercial generator installation.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Dock marine electrical in Seminole: safe power at the water
Docks sit in a harsh place. Salt, spray, sun and moving water attack every wire and fitting. Poor wiring can leak current into the water, which is a danger to swimmers. Done right, dock power is safe and reliable: marine-grade cable, sealed boxes, corrosion-proof hardware and ground-fault protection on every outlet.
Dock and lift work we do
- Shore power: pedestals and receptacles for boats at the dock.
- Boat lifts: dedicated circuits, disconnects and switches for lift motors.
- Lighting: dock, piling and walkway lights, often with timers or photocells.
- Outlets: weather-resistant, ground-fault protected receptacles.
- Repairs: replace corroded boxes, brittle cable and failed switches.
- Inspections: a check of bonding, grounding and leakage on older docks.
Why ground-fault protection matters
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
A damaged cord or a corroded connection can send stray current into the water. People swimming nearby can be hurt, even with no visible spark. A ground-fault device trips when current leaks, long before it reaches a dangerous level. Dock outlets and many feeders need this protection, and we test it at each visit.
Marine-grade materials
Ordinary indoor wire does not last on a dock. We use tinned copper conductors, UV-resistant jackets, stainless or composite hardware, and sealed fittings. Conduit is rated for sun and moisture. Boxes are listed for wet locations and are mounted high enough to stay above storm surge when the design allows.
Local waterfront
Seminole sits near Boca Ciega Bay, Long Bayou and Lake Seminole, and many homes in the area have docks or seawalls. Brackish water speeds corrosion, and storms push surge across low lots. We design for those conditions, with raised panels, sealed penetrations and cable routes that avoid places where water pools.
Bonding and grounding
Metal parts such as piling hardware, ladders and lift frames are bonded to a common point. This reduces voltage differences between metal parts, which can matter in water. The dock panel is grounded back to the house system with proper conductors. We check these connections for corrosion when we visit.
Permits and inspections
New dock circuits and boat lift wiring are permitted and inspected. Waterfront work may also involve other agencies, and we tell you when that applies. We handle the electrical permit and leave you with a labeled panel and a short record.
Storm care
Before a storm, power to the dock should be turned off at the panel. After a storm, do not touch a dock or lift until the system has been checked. Call us for a post-storm inspection at (727) 476-7079.
Typical parts of a dock electrical system
- Service: a weatherproof panel on a post or seawall, with a main breaker and a disconnect.
- Feeders: marine cable in conduit or direct-burial, supported against tides and boat wakes.
- Outlets: ground-fault protected, in-use covers, stainless screws and gasketed boxes.
- Lights: LED piling caps, step lights and floodlights with photocells.
- Lift circuits: disconnect, motor-rated breaker and a limit-switch check.
Common problems we repair
Green corrosion inside boxes, chewed or cracked cable, sagging conduit, outlets that fill with water, GFCIs that trip on humid mornings, light fixtures that flicker after rain, and lifts that stall under load. Many come from the wrong materials, not bad luck. We replace them with marine-rated parts and seal every entry.
Pre-hurricane and post-storm steps
Before a storm, switch off dock power, secure loose fixtures and note where panels sit. After the storm, do not restore power until an electrician checks the dock, the lift and the feed from the house. Surge can ruin a lift motor or a panel, and wet wire can hide a dangerous fault.
Low-voltage and solar dock lights
Some owners prefer low-voltage lighting with a small transformer on shore. It cuts shock risk and runs cool, but the cable and connectors still need marine ratings. Solar caps are simple and need no wiring, though they dim on cloudy days and in shade from palms and mangroves. We explain the trade-offs and install what fits your dock and your budget.
Working with seawall and dock builders
Many owners hire a dock builder for pilings and decking. We coordinate the electrical work with them: sleeves and chases go in before decking, panels are placed on posts that can carry them, and lift circuits are ready on the day the lift arrives. A short planning call prevents rework and keeps the project moving.
Mangroves, manatees and rules at the shoreline
Waterfront lots in Pinellas often border mangroves and seagrass, and docks may fall under protected-habitat rules. Lighting near the water can also affect nesting birds and sea turtles in some areas, so shielded, warm-colored fixtures are a good habit. We tell you when a design may need an outside review before work begins.
Common questions
Can I plug my boat into a regular outlet? Boats need the right shore-power receptacle and cord for the load. We install the proper pedestal or inlet, with ground-fault protection.
Do boat lifts need their own circuit? Yes. Lift motors draw a lot of current and need a dedicated, protected circuit and a disconnect.
Is old dock wiring safe? Not always. Corrosion, damage and missing protection are common. We inspect and recommend repairs.
Can you add lights to my dock? Yes. We use marine-rated fixtures and wiring, often on a timer or photocell.
What should I do after a storm? Keep the power off and stay out of the water near the dock until an electrician inspects it.
Our trucks leave the shop on Seminole Blvd and work near 113th Street North, Lake Seminole Park, Long Bayou, Ulmerton Road, Lake Seminole. We also serve North Redington Beach, Largo, Bay Pines, Pinellas Park, Indian Rocks Beach, Redington Shores, Indian Shores and Madeira Beach.
Up: Dock Marine Electrical across Tampa Bay · For everything we do locally, see Seminole electrical service.
Nearby: Bay Pines · Madeira Beach · Redington Beach · North Redington Beach
Call or text (727) 476-7079 for dock marine electrical in Seminole, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
