Need mobile home electrical repair in Bay Pines? Keywest Lights & Electric handles mobile home electrical repair in Bay Pines for manufactured homes on lots and in parks. We are licensed and woman-owned, and we repair pedestals, feeders, panels, outlets and bonding so the home is safe and steady.
Request mobile home electrical repair in Bay Pines
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
Our Bay Pines pages cover commercial generator installation, commercial electrical service, backup generator hookups and home EV charging too. We also handle jellyfish lighting and panel upgrade replacement.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Mobile home electrical repair in Bay Pines: power for manufactured homes done right
Roughly one home in six in Bay Pines is a manufactured home, which is a high share for a Pinellas community. These homes have their own electrical rules: a pedestal or meter, a feeder to the house, a bonding path through the frame and a panel with limited space. Salt air and humidity speed up wear on every part.
What we repair
- Pedestals and posts: rusted boxes, loose receptacles, cracked bases.
- Feeder cables: damaged insulation, chewed wire and poor splices.
- Main panels: worn breakers, scorched buses and missing covers.
- Outlets and switches: loose, dead or hot devices.
- Bonding and grounding: the frame, the pipes and the ground rod.
- Skirting clearances: cable and conduit near the ground.
- Add-on circuits: air conditioners, water heaters and lanai power.
The pedestal
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
The pedestal holds the meter or breaker, and many sit in sun, rain and sprinkler spray. We replace corroded boxes, seal conduits and set the post so it stands level and firm. We also check the receptacles and the breaker inside.
The feeder
The feeder runs from the pedestal to the home. Over time, ants, lawn equipment and heat can damage it. We test the cable, replace it when the insulation is brittle and protect it with conduit where it is exposed.
Four-wire service
Modern manufactured homes use four-wire feeders with separate neutral and ground. Older ones often have three wires, which can leave the frame energized. We check what your home has and explain the options.
Bonding the frame
The metal frame, the water pipes and the gas line all need a bonding path. A loose or missing bond can turn a minor fault into a shock hazard. We test continuity and fix what we find.
Aluminum wiring
Some older manufactured homes use aluminum branch wiring. We use rated connectors, inspect each device and suggest copper pigtails or replacement when risks stand out.
Top-mounted equipment and air handlers
Top-mounted air conditioners and vent fans have their own wiring. We inspect the disconnects, whips and connections, and repair what sun and moisture have worn.
Breakers that trip
A mobile home panel can be small, with circuits doubled up. We test each breaker, check for overloaded runs and add a circuit where the load calls for it.
Storm preparation
Manufactured homes face wind and water. We check strap points, pedestal footing and the weatherhead, and we make sure shutoffs are labeled for the family.
Park rules and landlords
Many parks have rules on who may touch the pedestal and what the lot owner covers. We work with park management and keep a record of what we did for you.
Aging in place
With many older residents here, we add night lights, easy-to-use switches and smoke alarms that wake a heavy sleeper. We can also set up a standby power option for medical devices.
Permits and inspection
Repairs to a pedestal, feeder or panel need a permit and an inspection. We prepare the filing, schedule the visit and correct anything flagged.
Tie-downs, skirting and clearances
Anchors and straps hold the home against wind, and skirting hides the underside. We keep cable above the ground, away from sharp skirting edges and out of the path of mowers. Where wire must pass through a skirting panel, we add a bushing and sealant.
Crawl space work
Under the home, wires, duct and pipes share a tight space. We use a creeper, a bright light and a respirator, check junction boxes for loose lids and replace any splice that was left uncovered.
Lights, fans and fixtures
Many manufactured homes use thin ceiling panels with no framing above. We choose light-weight fixtures and special brackets, avoid heavy hangers and test the fixtures for heat.
Surge protection and storms
A whole-home surge protector at the panel shields appliances from spikes. We also check the pedestal’s ground rod, the continuity of the bond and the weather seal at every opening.
Spotting trouble early
Dimming lights, a tingle from a faucet, a warm plate or a breaker that will not stay on are all signs to call. A short visit now can prevent a long outage later.
Water heaters, furnaces and appliance circuits
A manufactured home packs a compact water heater, an air handler and a range into small rooms. We confirm each appliance has the right breaker, a short whip and a secure disconnect. Loose strain reliefs and crowded junction boxes get fixed on the spot.
Added carports, sheds and porches
Owners often add a carport, a shed or a screened porch to the lot. We run safe feeders with proper depth, weatherproof boxes and ground-fault protection, so the new space does not stress the home’s panel.
Warranty
We stand behind our workmanship for 2 years, or 5 years with a Member Care Plan.
Before we arrive
Tell us if you rent the lot, whether the park manages the pedestal and what symptoms you see. Clear a path to the panel and pedestal.
Common questions
Who is responsible for the pedestal? It depends on the lot and the park. We help you sort out who handles which part.
Is a three-wire feeder safe? Not for new installs. We test what you have and recommend a four-wire feeder.
Can you add a circuit for a lanai or a unit? Yes, once we confirm the panel has room and the feeder can carry the load.
Our trucks leave the shop on Seminole Blvd, about a mile away, and work near Bay Pines Boulevard, Boca Ciega Bay, Long Bayou and Seminole Boulevard. We also serve Madeira Beach, Largo, Redington Beach, Kenneth City and Bardmoor.
Up: Mobile Home Electrical Repair across Tampa Bay · For everything we do locally, see Bay Pines electrical service.
Nearby: Seminole
Call or text (727) 476-7079 for mobile home electrical repair in Bay Pines, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
