Does your Bay Pines meter base look damaged? Keywest Lights & Electric handles meter base replacement in Bay Pines for houses, mobile homes and small shops. We are licensed and woman-owned, and we replace cracked, rusted or burned meter sockets and prepare the service for the utility’s reconnect.
Request meter base replacement in Bay Pines
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
In Bay Pines, we also take a commercial electrician, backup generator hookups, backup power for a business and EV charger installation.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Meter base replacement in Bay Pines: the socket that carries the whole service
The meter base is the box on the outside wall that holds the meter and connects the service cable to your panel. Salt, sun and age wear it down. Many Bay Pines homes date from around 1970, and original meter bases are common, some with rusted jaws, cracked covers or loose lugs. A bad base can burn, buzz or lose power during a storm.
What we replace
- Corroded or rusted bases: salt-eaten cases and loose covers.
- Burned jaws: blackened contacts that arc under load.
- Cracked or broken sockets: damaged by impact or sun.
- Old two-wire bases: outdated types with no room for growth.
- Combination meter and disconnect units: modern all-in-one housings.
- Ringless and ring-type sockets: matched to local requirements.
- Conduit and riser: the pipe that carries wires down from the weatherhead.
Signs to watch
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
Look for rust streaks, a cover that will not close, a buzzing meter, a warm base or blackened plastic. Flicker across the whole house, especially in wind, can mean a loose jaw. An insect nest in the base is another reason to call.
The visit
We inspect the base, the riser, the weatherhead, the service cable and the grounding. We note how your panel connects and whether the meter base can be replaced alone or needs a full service upgrade.
Coordination with the utility
A meter base replacement means temporarily disconnecting the service. The utility sets the meter and reconnects power once the work passes inspection. We plan the visit so the outage is as short as possible.
Choosing the new base
We select a base rated for your service size, with the right number of jaws and a sealed case. For coastal homes, we favor heavy-gauge or corrosion-resistant models and add gaskets and sealant at every opening.
Riser and weatherhead
The pipe from the meter up to the weatherhead often rusts or pulls loose. We replace the riser, add a new weatherhead, re-form a drip loop and use new straps.
Grounding
A new base needs a sound ground and bond. We test the ground rod, add a second rod where required and tie the neutral, the panel and the pipes together properly.
Storm damage
After a storm, a base can be pulled from the wall, cracked by debris or flooded. We respond quickly, make the service safe and prepare the inspection so the utility can reconnect.
Mobile homes and pedestals
A mobile home often has a pedestal with a meter base and a breaker. We service those too, replacing a corroded pedestal and sealing every conduit entry.
Permits and inspection
Meter base replacement is permitted work, and the inspector must approve it before reconnect. We prepare the filing, schedule the inspection and handle the follow-up.
Reading the jaws and the lugs
We look at the meter jaws for pitting, the lugs for discoloration and the case for hairline cracks. A jaw that no longer grips the meter blade makes heat and noise, and the fix is a new base, not a tighter screw.
Sealing against wind-driven rain
Rain runs along the wall and into a gap at the top of the base. We flash the top edge, seal the sides and run a drip loop on the cable so water falls away. A clean seal keeps ants and moisture out for years.
Pedestal, post and wall mounts
A meter base can sit on a wall, a pedestal or a freestanding post. We choose the mount that fits your lot, set posts in concrete and secure wall mounts to solid masonry or framing.
Temporary service
After a storm, a temporary service lets you recover while repairs continue. We build a safe, inspected temporary setup and replace it with the permanent base when materials arrive.
Records and the property file
We note the amp rating, base type, date and permit on a short sheet and keep a copy for you. It is handy for a future sale or an insurance claim.
Fire ants, wasps and geckos
Insects move into a loose meter base, nest near the lugs and chew insulation. We clear the space, seal gaps with putty and fit a gasketed cover that closes tight.
Smart meters and communication
A newer meter may include a radio module. We keep the base clear of metal clutter that would block the signal and follow the utility’s standards for mounting height and clearance.
Equipment clearances
The area in front of the meter must stay open, and the base must sit at a set height. We measure those distances, move a hose bib or a planter if they crowd it and mark a clear space.
Warranty
We stand behind our workmanship for 2 years, or 5 years with a Member Care Plan.
Before we arrive
Clear shrubs and stored items near the meter and tell us about any storm damage, buzzing or insect nests.
Common questions
Who replaces the meter itself? The utility sets and removes the meter. We replace the base and prepare the service for reconnect.
Why is my meter base rusting? Salt air, humidity and sprinklers corrode the metal. We replace the base and seal it well.
Will my power go out? Yes, for the time the work takes and the inspection. We plan to keep it short.
Our trucks leave the shop on Seminole Blvd, about a mile away, and work near Boca Ciega Bay, Bay Pines Boulevard, Seminole Boulevard and Long Bayou. We also serve Largo, Redington Beach, Redington Shores, Indian Shores and Bardmoor.
Up: Meter Base Replacement across Tampa Bay · For everything we do locally, see Bay Pines electrical service.
Nearby: Seminole
Call or text (727) 476-7079 for meter base replacement in Bay Pines, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
