Need home remodel addition electrical in South Highpoint? Keywest Lights & Electric performs home remodel addition electrical in South Highpoint when you open existing rooms and also add space, so old circuits and new framing have to meet. We are licensed and woman-owned, and we roll from Seminole Blvd, a drive of about 7 miles.
Request home remodel addition electrical in South Highpoint
Tell us what you need and where the work is. A licensed electrician will reply with next steps and a time to visit.
You can also book us in South Highpoint for backup generator hookups, JellyFish eave lighting, emergency electrical calls and a home battery system. The same crew also takes commercial generator installation, ev charger installation, generator interlock transfer switch, panel upgrade replacement and permanent lighting.
Call or text (727) 476-7079 · open 24/7 for emergencies · request a quote online

Home remodel addition electrical in South Highpoint ties the old house to the new room
This is the combined job. We fish or open a 1970s wall. We move a doorway. We relocate a switch. Then we land the new addition on the same system. The standalone new-room job, with no work in the old house, belongs on the addition page. A kitchen-only project belongs on the kitchen page. Here we plan both halves together so a new hall does not leave an old bedroom on a dead switch.
Opening a 1970s wall
Plaster, thin paneling and shallow boxes are common in the original rooms. We locate a stud, we fish where we can, we open a clean patch where we must and we do not rip a whole wall because one cable has to move. If we find cloth remnants or an ungrounded box, that is a line on the quote, not a silent extra.
Shared walls in a duplex
- Florida electrical contractor license EC13014717, licensed & insured
- Woman-owned business based at 6248 Seminole Blvd, Seminole FL 33772
- 2-year workmanship warranty, 5 years with a Member Care Plan
- SPAN Authorized Installer and Home Depot preferred contractor
- Open 24/7 for electrical emergencies: call or text (727) 476-7079
Duplexes are common on these streets. A remodel that opens a shared wall has to stay on the correct meter. We map both cans before we cut, and we stop if the cable belongs to the other unit. Owner approval is required when you rent.
Joining the addition to the old plan
The new room needs a door switch that also makes sense from the old hall. We keep three-ways honest, we extend a smoke-alarm feed when the plan requires it and we do not leave the old porch light on a switch that now sits inside a closet. The directory in the original can gets the new and the moved circuits, not a sticky note on a stud.
What this combined scope usually includes
- Open-wall corrections: in the rooms you are already remodeling.
- Relocated switches and receptacles: at new doorways and new islands of furniture.
- The addition rough-in: boxes, cable and, when needed, a feeder.
- A single load calculation: for the old house plus the new square footage.
- One directory: so both halves are labeled in the same can or subpanel.
Temporary power during the remodel
Families live here while walls are open. We can keep a temporary kitchen or a bedroom circuit live, we cap unused cables and we do not leave a live stub in a child’s room. A working-age street with kids in about a quarter of the homes needs that caution; this is not a vacant teardown by default.
How the visits are sequenced
We walk the old rooms and the new footprint on the first visit, we write one scope and we rough while the walls are open. Inspections, if required, happen before cover. Devices and fixtures come after paint. The truck is marked, and we give a window for each of those steps.
Permits for a combined project
Opening the old house and adding a room usually needs a permit. We handle the paperwork for the electrical portion, we are present for the reviews and we do not name a reviewing desk. The parcel’s unincorporated Pinellas County rules apply even when the mail says Clearwater.
Warranty on the combined work
Labor and the circuits we install or relocate are under a two-year workmanship warranty. Homes on the Member Care Plan at /member-care-plans/ receive five years on that same work. Rooms we did not open stay outside that promise.
A fish tape, a plaster lath and a shallow old-work box
In the original rooms we use a fish tape where the wall will allow it, and we switch to a clean plaster patch and a shallow old-work box where the lath will not let a deep device sit flush. We do not hammer a modern deep dimmer into a 1970s pancake box.
A laundry wall that moves and a dryer receptacle that stays
A laundry wall that moves during the remodel can leave a dryer receptacle on the wrong side of a new closet. We relocate that 240-volt point with a listed box and the same circuit identity, and we test it before the machines come back. A dryer cord under a new sole plate is not a plan.
A doorbell transformer and a window-unit circuit
An old doorbell transformer often sits in a j-box that gets buried when a wall moves. We relocate it to an accessible box and we keep the chime working. A window-unit circuit that sat on an old exterior wall is moved or retired so it is not left inside a new closet with no airflow.
A pantry alcove and a capped cable
An alcove that becomes a pantry needs a receptacle and a light of its own, and a cable that used to feed a demolished wall gets capped in a box, not taped in a void. We show you those caps before the wall is closed.
A hallway arch that moves and a three-way that has to follow it
When a hallway arch moves, the three-way at each end has to follow the new opening. We remake those travelers and we test both positions before the plaster patch is finished. A dead-end switch in a new closet is opened and corrected.
A ceiling fan box in a room that changes shape
A room that changes shape can leave a ceiling fan box off-center or on a joist that is no longer in the middle. We move that box to a listed fan-rated support in the new center, and we do not reuse a thin pancake for a fan.
A porch that becomes interior space
A porch that becomes interior space still has old exterior boxes and a weather-rated fixture in the wrong place. We retire or relocate those boxes, we fill the old holes and we bring the new interior points up to a normal wall height. A wet-location cover left inside a new living room is removed.
A crawl hatch light
If the house has a crawl hatch or a low storage hatch that moves during the remodel, we add a listed light and a switch at the hatch so no one crawls in the dark.
Common questions
How long does home remodel addition electrical in South Highpoint usually take? A: It follows the builder’s wall schedule: a planning visit, a rough-in, then a finish. A tight service or a hidden fault in an old wall can add a trip.
Is this the same as a new-room-only job? A: No. This page is for work in the existing house plus the addition. A new room alone is the addition page.
Can you keep power on while we live in the house? A: Yes, for the circuits we agree to keep live. We cap the rest and we write that plan before we start.
From the Seminole Blvd shop, South Highpoint is about 7 miles away. We know the streets around 34th Street North, Ulmerton Road, Roosevelt Boulevard and 49th Street North and also take work in Largo, Clearwater, Feather Sound, Pinellas Park and St. Petersburg.
Up: Home Remodel Addition Electrical across Tampa Bay · For everything we do locally, see South Highpoint electrical service.
Cities next door: Seminole · Bay Pines
Call or text (727) 476-7079 for home remodel addition electrical in South Highpoint, or book online. Business hours 7 AM–5 PM, weekend service, 24/7 emergency calls.
